Richard General Contracting
Black-framed multi-slide glass door stacked fully open onto a covered patio

Doors & Windows

Door & Window Installation in San Diego County

In this climate a wall of glass that opens is not a luxury detail, it is the difference between a house with a backyard and a house that uses one. Get the opening right and the patio becomes part of the living room eight months a year. Get it wrong and you have an expensive door that sticks, a threshold that leaks, and stucco cracking at the corners within two winters.

01The Scope

Why installation matters more than the brand

Almost every door and window failure we get called out to is an installation failure rather than a product failure. The opening was not square, the sill was not sloped, the flashing was lapped the wrong way, or the unit was shimmed to close rather than shimmed to plumb. None of that shows on day one. All of it shows by the second rainy season.

We measure the actual opening rather than the drawing, pull the old unit, and inspect what is behind it. On coastal homes there is often rot in the sill or the king studs, and we repair that before the new unit goes in rather than trapping it. Then we set the unit plumb, level, and square, flash and pan it properly, foam and seal the perimeter, and finish the interior casing and exterior trim so it reads as original.

The work covers multi-slide and bi-fold systems, french and entry doors, sliders, single-window replacements, and full-house retrofits, plus the header and framing work when an opening is getting bigger than it was.

Large sliding glass door set into a new opening in a Temecula home
New french doors installed and trimmed in a San Marcos home

02Recent Doors & Windows

Different properties, same standard.

New exterior door opening framed and prepped during a Rancho San Diego remodel
Door and window openings cut and prepared in a stucco wall
French doors opening from a finished dining room addition onto the patio
New window trim and siding finished on an Escondido exterior
Exterior wall opened up for new doors and windows during a remodel

03Timeline

A single door or window is usually one to two days. A full-house retrofit runs one to two weeks. Multi-slide systems have real lead times from the manufacturer, so we order first and demo second.

04Typical Investment

The unit is most of the cost on a straightforward swap. What moves the number is structural: widening an opening needs a new header and sometimes engineering, and rot found behind the old unit has to be repaired before anything new goes in. We tell you what we find with photographs before we price it.

Every estimate is written for your exact house and scope, free, after a walkthrough. We will go through the numbers with you.

05Free Estimate

Start with a walkthrough.

Tell us about the project and we will call within one business day. Or skip the form: (951) 837-1300

Free, no obligation. We reply within one business day.

Call or TextFree Estimate