Richard General Contracting
White oak built-in cabinetry, floating shelves, and board-and-batten wainscoting beside a plaster fireplace

Carpentry

Custom Carpentry & Finish Work in San Diego County

Carpentry is the part of a house you touch. The stair rail under your hand, the casing your eye follows, the built-in that makes a room feel finished instead of furnished. It is also the part where shortcuts show up fastest, because a joint that is off by an eighth is invisible in a photograph and obvious in person. It is the trade this company grew out of, and we still measure the rest of our work against it.

01The Scope

The trade underneath everything else we build

Luke earned his Journeyman Carpenter card through Local 619 and his Fabrication Technician card through Local 47, which in practice means years of being measured against a standard set by people who had done it longer. That is the standard the work is held to. It is why a scribe lands tight against an out-of-plumb wall, and why a mitre still reads clean after a Santa Ana dries everything out.

The work runs from architectural millwork and built-in cabinetry to stair parts, wainscoting, crown, baseboard, door and window casing, mantels, and timber work. Interior or exterior. We work in oak, walnut, cedar, redwood, and fir, and we will tell you which one is wrong for your application before you pay for it.

On outdoor structures the same standard applies where nobody expects it: tongue-and-groove ceilings with tight seams, post wraps that are square to the world, exposed trusses cut on site instead of ordered in, and hardware that is doing structural work rather than decoration.

Cedar rafters and tongue-and-groove ceiling seen from underneath a Rancho Bernardo pavilion
Cedar ridge detail with a blackened steel bracket at the peak of a gazebo

02Recent Carpentry

Different properties, same standard.

Truss and tongue-and-groove ceiling detail inside a finished pavilion
Horizontal redwood fence with even reveals and clean end cuts
Kitchen with a poured concrete countertop and custom cabinetry in San Marcos
Black metal commercial railing installed along a Solana Beach deck
Pavilion posts and beams set square with temporary bracing in place
Custom slatted bar front and back bar millwork in a San Diego commercial space

03Timeline

Built-ins and trim packages usually run one to three weeks on site. Custom millwork that has to be fabricated adds lead time up front, and we order it before demo rather than after.

04Typical Investment

Species and complexity set the price. Paint-grade poplar trim and clear white oak millwork are not the same job, and a curved or scribed run costs more than a straight one because it takes longer to make it look effortless. We quote carpentry as its own line so you can see it.

Every estimate is written for your exact house and scope, free, after a walkthrough. We will go through the numbers with you.

05Free Estimate

Start with a walkthrough.

Tell us about the project and we will call within one business day. Or skip the form: (951) 837-1300

Free, no obligation. We reply within one business day.

Call or TextFree Estimate